G&L Custom Shop serial number and logo laser etching ...

Prepping back of headstock for Custom Shop logo. Once the laser does its thing, it is then ready for its "other half" of the process.



Mahogany inserts prepped and ready before installation.


After the mahogany CS logo has been inserted and the etched serial number has been stained with a walnut finish.

That's cool. I thought the logo was just laser etched like the serial number rather than a Mahogany insert. One day I might actually have one to look at and play.

Do you know if they would make a Custom Creations guitar with a three bolt neck and micro-tilt?

Tom

Do you know if they would make a Custom Creations guitar with a three bolt neck and micro-tilt?

Tom

Hehe...going after the holy grail of sacred cows there? I'd love to see G&L making 3 bolt, micro-tilt necks once again, but I suspect that would be too much like a doorway into supporting older models with replacement necks (sigh). I expect if they did offer it, they charge a mint - just to discourage people from "going there".

(edited for tone)

Last edited by DanDoulogos on Fri Jul 06, 2018 8:44 am, edited 1 time in total.

Those are so cool!

y2kc

Those are so cool!

y2kc

+1
I was impressed even before scrolling to to the 'hog' insert pics.
Wow! ...cool idea

Here we have two necks in contrasting colors both Maple, one roasted with a Quilted Maple logo and the other has a Mahogany inlaid logo.

Closeup detail of a Roasted Maple neck with a Quilted Maple logo insert.

Yes Craig, that was the post I was referring to in the other post. Thanks for clearing up my fuzzy mind...

Tom

Freakin' amazing! That's some serious craftsmanship and detail. Wow!